|
|
LinkBack | Thread Tools | Display Modes |
#1
|
||||
|
||||
Tighten bonnet release
Can someone please tell me how to tighten this.. atm when U pull it... it doesnt do anything unless someone is pulling up the bonnet at the same time (or I use a bbq fork to wedge the lever open between the foot pedals while I run to the bonnet and pull it up) Thanks!
|
#2
|
||||
|
||||
Buy a set of bonnet struts of me and I will fix it for ya...
|
#3
|
||||
|
||||
they are in the plan..but not atm..I need to keep the funds for fmic/turbo upgrade which is halfway there..I wish I could grab them now mate but I just cant!
|
#4
|
||||
|
||||
Ok no probs.
Check that the bonnet is lined up properly with the height of the guards. On the corners of the rad support are the rubber adjusters. Wind these up to move it up, and down to move it down. When this is right try opening it. If no luck still, remove your grill and from memory there are 2 12mm bolts. Loosen these and push the catch down a smidge. Tighten bolts and try again. Repeat as necessary. |
#5
|
||||
|
||||
will try tonight..thanks heaps!
|
#6
|
||||
|
||||
Try getting a new mechanic. They usually get stuck if not lubed properly each service. Spray some wd40 or a little engine oil down in the lock mechanism under the bonnet.
__________________
Version 6 STI |
#7
|
||||
|
||||
ok got it working..I pushed the catch down..raised the rubber adjusters a little and lubed the latch! all good now thanks all!
|
Tags |
bonnet, release, tighten |
|
|