I recently bought some fog light covers, went to fit them earlier - I thought that you remove one of the screws holding to fog lights in (bottom outer), then use a longer screw in the same hole to attach the cover - doesn't line up! How have you guys fitted yours? Do you just use a self tapper and screw into the plastic?

Help appreciated.

They need a bracket. Pretty easy to make.

Note that when you screw your covers on, they are just as easy
for a thief to screw off and steal. Think of an alternative way to hold them
which is not so obvious. That way they are less likely to get stolen.

__________________
[SIGPIC][/SIGPIC]

My flame suit is on. Give it your best biatch.


[COLOR="Red"]My STI's carbon emissions are offset by killing puppies.[/COLOR]

If you want the genuine brackets they are about $20 ea side. If you get the proper bracket you can leave the old foglights in.

I found on my old car the best way to stop them being stolen was to use a really weird screw. I got the bit to do it up from sweetmans.

Good luck.

__________________
Losing is worse than death. You have to live with losing....

Its a tricky one mate gotta be calm and steady..

I got some to the brackets are absoulutly sh!t do you get the genuine ones from subaru?

__________________
M POWER

ive asked subaru for the brackets. they didnt know what the fuck i was on about ?

they got a part number ?

Fitted mine with the classy cable ties, no screws needed, they just clipped in.

Cable Ties FTW!!!

__________________
345hp @ 1.4bar

so if ya need my98 foglight covers u kno who too see :P

haha nah 99 front bar, with ebay spec mesh foggie covers,
maybe ill run a live electrical wire onto the covers, so if someone goes for a pinch, they will get a little zap

__________________
345hp @ 1.4bar

hi-tec! to bad plastic aint a good conductor of electricity :P