|
Register | Diddy Kart | Articles | All Albums | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
|
LinkBack | Thread Tools | Display Modes |
#311
|
||||
|
||||
Is that your hp target?
__________________
Bye bye betty blue. Hello F6. |
#312
|
||||
|
||||
__________________
605whp Quarter Mile in 10.9 seconds @ 135mph /217kph 0-100 kph 3.2 seconds |
#313
|
||||
|
||||
9's are the new 10's as they say!
__________________
Bye bye betty blue. Hello F6. |
#314
|
||||
|
||||
Quote:
Do GD's not have that or have you re-routed the smaller breather line to that pump to have it still function?
__________________
Balls. |
#315
|
||||
|
||||
That side of things is all OEM still.
I've just re routed the supply and engine breather lines. The venturi pump on the passenger side is still in situ
__________________
605whp Quarter Mile in 10.9 seconds @ 135mph /217kph 0-100 kph 3.2 seconds |
#316
|
||||
|
||||
Minor update, managed to get hold of a front grille.
What a nightmare that was. Can't get them new unless imported from Japan costing a small mortgage. Jokers on ebay wanting silly money Breakers who will only sell them as front end conversions or as complete bumper at north of £500. ($1000) I nearly opted for a Carbon set but I really wanted the OEM Look. Anyway finally found one and painted it.
__________________
605whp Quarter Mile in 10.9 seconds @ 135mph /217kph 0-100 kph 3.2 seconds Last edited by dazdavies; 11-08-2020 at 05:17 PM. |
#317
|
||||
|
||||
Hoping to build up some momentum with this now.
Kicking off with delivery of my new brakes. These things are a work of art and I'm really pleased I went for them I'm also sorting out the fuel system properly this time round too but have had a slight rethink of my original plans. I've previously used rubber nitrile hoses but got fed up with the smell of fuel. This time round I'm using PTFE hoses which should eliminate that. I'm running an AN8 line from pumps to rails which runs the length of the car. I'm also using one of the original hard lines as the return line but I've cut it prior to it going underneath the car to allow me to fit a 6an - hardline joiners so I can route it to my surge tank. I'm also going to be running a flex fuel setup so I have an ethanol sensor to go on too. Will hopefully get the fuel side of things finished this week. Will post more pics when I've completed it.
__________________
605whp Quarter Mile in 10.9 seconds @ 135mph /217kph 0-100 kph 3.2 seconds Last edited by dazdavies; 19-06-2021 at 06:12 PM. |
#318
|
||||
|
||||
Forgot to update this.
Quite alot has happened. I'll just sum it up with pictures... 500kms on it so far. It's good to be back driving it.
__________________
605whp Quarter Mile in 10.9 seconds @ 135mph /217kph 0-100 kph 3.2 seconds |
#319
|
||||
|
||||
good to see this is still kicking along!
__________________
R32 GTR - 800ish 60.7 Long Track at Barbs 57.6 at RAC Reverse circuit. |
#320
|
||||
|
||||
Honestly, one of the few reasons I still check on here is for this monster. I might send you a PM Daz, I’m looking to run a parallel fuel system, after a bit of input
__________________
Air is for pussies. |
Tags |
10, hawkeye, oem reliability., reliable ej25 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Evo 10 HKS/ARC/Misc bits | Captain Awesome | For Sale | 13 | 15-12-2012 02:48 PM |
Subaru introduces WRX Club Spec 10 for Australia | rss.feed | General Subaru Discussion | 0 | 08-04-2010 09:20 AM |
Boost Juice | BOMB3R | Non-WRX Discussion | 56 | 16-01-2007 06:05 AM |