Is this a normal thing with full size wings????
 

Just washed the beast and noticed that there is what I think it a layer of fiberglass matting starting to work its way out from under the rear wing.

Is about 3 in. in from each side about 1 1/2 in. long between bottom part of wing and the boot. About 2 mm sticking out.

If I was to unbolt the wing and reposition or remove it would I likely run into problems latter.

Would Subaru fix it under warranty????

I thought the original wings were made of ABS plastics or something like that. not fibreglass.

[QUOTE=Mister Two]I thought the original wings were made of ABS plastics or something like that. not fibreglass.[/QUOTE]

I think it is a layer of padding between the wing and boot. I think it is fiberglass but hard to tell cos was wet when I found it. Probably a layer of felt but that is why I am asking.

Never had that problem with my wing but imagine it is just felt between the wing and boot. Suggest you just loosen bolts and reposition yourself.

or take it back to subaru and go "oi you, fix this"

did you use a high pressure hose?

Yah I had same thing .. black kinda cloth like material poking a little bit.. just trim it carefully with a razor blade and rip it out of there.

Take it back to Subaru... Say fix it. If they don't fix it then have a look yourself...?

[QUOTE=BLUES]did you use a high pressure hose?[/QUOTE]

No Try not to waste to much water!!!!!!!

[QUOTE=POLARBEAR666]Yah I had same thing .. black kinda cloth like material poking a little bit.. just trim it carefully with a razor blade and rip it out of there.[/QUOTE]

Yea that is what my mate suggested but can just see the back of the boot or me wearing a dirty great gouge mark.