boost gauge and rev tacho instalation...
 

how hard is it too move the boost gauge? i need to move it up the pillar about 30 cms...as i have put in a new pillar mount, the soldering on the wires no probs i can do that, but what about the plastic tube thing? where the fuck does it go? will i need to get a new one? what the?

also putting in a rev tacho....now...how hard is it too put in too ?

neone ? i hear jamie is gay too?? :)

Ok the plastic pipe on the boost gauge from looking under my mates r33 comes from a T piece. The T piece is located sumwhere inbetween the return pipe that goes from ur BoV to the top of the block (not sure, its just a fitting that u put the hose on).

Broken down. Look for your BoV (stock or aftermarker). There will be a hose that goes from the BoV to your block. That hose will contain 1xT piece and a hose will T off into ur firewall. That is the hose the boost gauge needs to read the amount of boost it is running at one time.

Correct me if im wrong people, only going on my mates r33 and im fairly new to the whole turbo scene! :D

ah ok i shall have a look tday when i fin work...but it would be okay to take off and put a longer one in? dont have to do anything special that anyone knows of?

Dont think so, all the Hose from the T piece to the guage does is sense the PSI to show u how much bar you are running. Just check how they have run the old hose, and try run a new, and longer on (obviously) to where you need it to be.

Eric

ok cool i will try :)