Fair enough, can only go on what I've heard. Any recommendations on a good place to get it done?

im running 235/35/18 ventus k107 with a spacer and i have no rubbage with gaurds rolled :D

I had Des from AutoFX do mine. It was done about 2 years ago, maybe more. No cracking at all. He has the proper machine and uses a heat gun which I assume makes the paint more pliable. Only cost me $110 I think it was for the rears to be rolled.

I ran the Falken GRB's in 225/35/18. Rolled guards. Can't remember the offset though, was an 18 x 7.5 afaik.

stu from dentcraft rolled mine.

only 17" though, but continental 225's

[QUOTE=GX-REX]I had Des from AutoFX do mine. It was done about 2 years ago, maybe more. No cracking at all. He has the proper machine and uses a heat gun which I assume makes the paint more pliable. Only cost me $110 I think it was for the rears to be rolled.[/QUOTE]

Nice! I'll check em out. There's an Ozzy tyres opening up here on Saturday apparently so I'm gonna see what deal I can get there too...

Third times a charm.

Just so you know... The Tech9 site isnt entirely accurate. I bought a set of Nexen N3000 225/40 18's and on the site it says the load rating is 92h, but in the wall of the tyre it says 92y... Obviously a much higher rated tyre than they specify.

Im running 225/40 18 on my gc8 stock suspension. Very minor rubbing in the back only.

holy thread revival batman.....