I know this might be mentioned hundard times but i still can't find out which 2 wires need to be swapped in order to install the Power FC to MY98 WRX? Can anyone takes a photo of yours if you have one, much appreicate!!! Is it only 2 wires need to be swapped?

The only information I could find is on REXNET, but not sure if we need to sway the wire on the right as well? Photo is from the link below:
http://www.rexnet.com.au/forum/lofiv...hp/t77479.html

My rex is still at panel shop so i'll have a look of mine later, the power fc is now sitting at home....

Attached Thumbnails

 

PM Rossco,

I'll get back to you tonight.

In a nut shell, you need to swap the cam & Crank angle sensor wire positions at the ecu & that's it.

__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER]
[CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER]

Thanks