|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
13-08-2013, 12:57 PM
|
||||
|
||||
gc8 gearbox sensors / 02 gearbox sensors
so a thing i noticed when runnin the loom through on the racecar on the weekend. The gearbox sensors from the gearbox i got (02 wrx 4.44 gearbox) dont match the 99 gc8 loom i have running through the car
anybody know if i can splice them in? or do i need replacement sensors?
__________________
Wide Body GC8 WRX #217 Street Cars WA Full 04 STi drivetrain 08 JDM 207 Garrett 3076 xtr 
|
|
#2
13-08-2013, 09:56 PM
|
||||
|
||||
|
Please Explain?
What sensors? The speedo? If so, just screw in the one that suits your loom. If you meant the neutral and reverse switches they should be the same, if not just swap them over......
|
|
#3
13-08-2013, 10:49 PM
|
||||
|
||||
|
Yeah sorry Doug. Don't have the original sensors from the loom. Replacement box...
The Speedo isn't the same plug, either is the reverse/neutral one. Can I get replacements to fit or just cut wires?
__________________
Wide Body GC8 WRX #217 Street Cars WA Full 04 STi drivetrain 08 JDM 207 Garrett 3076 xtr
|
|
#4
13-08-2013, 10:56 PM
|
||||
|
||||
|
Don't cut any wires. Cut wires are the enemy of any reliable racecar.
Can you use the sensors from the donor car? All reverse light/neutral/speedo senders are interchangeable between all manual boxes, 5 and 6 speed.
|
|
#6
15-08-2013, 10:11 AM
|
||||
|
||||
|
the middle one on the car loom looks like it should fit in my gearbox loom but it doesnt as it a 4 pin going into 6 pin holder (only has 4 pins in the holder)
__________________
Wide Body GC8 WRX #217 Street Cars WA Full 04 STi drivetrain 08 JDM 207 Garrett 3076 xtr
|
|
#7
15-08-2013, 08:32 PM
|
||||
|
||||
|
Top pic, middle one goes to the gearbox loom for reverse and neutral switches. Right one is the exhaust sensor in the dump pipe right behind the turbo, left one is rear 02 sensor (not used in your setup)
Bottom pic, right hand plug is the reverse and neutral switches but the wrong plug, you need to get a 4 pin one instead of the 6 pin one. (6 pin socket has two unused that are reserved for DCCD or dual range warning lamp on applicable models) Small 2 pin on the left of the bottom pic is the speedo but you need to locate the appropriate socket in your loom (not pictured) to see if it's the right sender. There are a couple of different types.
|
|
#8
15-08-2013, 08:40 PM
|
||||
|
||||
|
Thanks Doug. Will look for the Speedo connector...
Hints in where to start?
__________________
Wide Body GC8 WRX #217 Street Cars WA Full 04 STi drivetrain 08 JDM 207 Garrett 3076 xtr
|
|
#9
19-08-2013, 12:14 PM
|
||||
|
||||
|
ok, so the middle switch in the first pic was made to fit the right plug in the second pic.
matched up fine but when i attached the power to the car on saturday and put the car in reverse no reverse lights worked?
__________________
Wide Body GC8 WRX #217 Street Cars WA Full 04 STi drivetrain 08 JDM 207 Garrett 3076 xtr
|
|
#10
19-08-2013, 12:18 PM
|
||||
|
||||
|
still no idea about speedo... found a single black wire that is all alone? could that be it?
__________________
Wide Body GC8 WRX #217 Street Cars WA Full 04 STi drivetrain 08 JDM 207 Garrett 3076 xtr
|
|
| Tags |
| 02, gc8, gearbox, sensors |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Polyurethane or carbon gc8 02 style scoop?? | tommo | Cosmetic | 13 | 15-03-2012 09:42 AM |
| will an 02 sti tmic fit my gc8? | fsk | Mechanicals | 3 | 20-08-2010 12:10 PM |
| 02 STI Bonnet scoop fit GC8? | V5 2.2L | Cosmetic | 8 | 03-02-2010 01:50 PM |
| Anyone need a copy of the Factory GD -> Sti service and diagnostic manual? | Rossco | General Subaru Discussion | 15 | 19-04-2009 12:54 AM |
| 02 sti bonnet scoop that fits a gc8 | shauno_18 | For Sale | 2 | 28-10-2008 05:12 PM |
1Likes
Linear Mode
