The brant control module is under the center console just below the radio on the left hand side - remove the glove box and you will see it
http://www.rexnet.com.au/forum/index...e=post&id=5484
its secured with just one bolt
undo that and then you can pull it out enough to remove the cover to reveal the 3 relays (3 large black boxes) which require resoldering on the back side
if needed you can unplug the keypad harness which is the small telephone cable type plug
you may also have an ignition key barrel problem too
when the barrel becomes worn you get the same result
this is detected by wriggling the key around in the ignition untill it works
there is a patch cable available from subaru for this problem
"KEY INSERT SWITCH PATCH HARNESS SAA9003"