Thread
:
alarm/ keypad
View Single Post
#
6
14-06-2009, 09:22 PM
Rexy03
BLUE TEAM
Join Date: Aug 2007
Location: Australind
Posts: 687
Thanks: 0
Thanked 0 Times in 0 Posts
Copied from Rexnet - Originaly posted by BMH
Quote:
This is a fix for intermittent cut outs, failure to start or have the fuel pump prime upon start up due to dry or poor soldiering of the components on the PC boards.You will not need to disconnect the brant module to do this task.
This should take you about 20-30 min max providing you take your time.
Tools needed are :-
Soldiering iron
Soft core / resin core soldier
No 2. size phillips head screw driver
1. Remove glove box area. This includes the 7 screws and retaining clip in the door jam area.
2. Pull the glove box down and look for this Box
Remove the 2 retaining screws holding the module to the car.
3. Remove the 2 screws that hold the brant box together.
4. Turn the PC board around so you can see the soldier points on the back of the board.
Retouch / soldier all the points marked in circles. These are the fuel pump, imobiliser, ignition relays power points and coil points.
5. Now do the reverse of what you just did and re-install the brant module into the cover, screw it back together. Now re-attatch the module to the car body point. Re-install the glove box and your done.
Hope this helps some of you that have been having issues with intermittent cut out, and failure to start.
Note these pics are for GD models
the control module is located in a different place in GC models - under the driver side i believe.
Rexy03
View Public Profile
Send a private message to Rexy03
Find all posts by Rexy03