View Single Post
  #1  
Old 11-09-2011, 07:17 PM
oneten oneten is offline
DCCD Donut Driver
Member
 
Join Date: Aug 2010
Location: Perth, Inside my engine bay
Posts: 95
Thanks: 0
Thanked 0 Times in 0 Posts
oneten at standard level
Default 550cc Injectors, Bosch 040 & HKS SSQV Blow Off Valve

Hey Guys,

Got a couple of things Im wanting to clear:

BOV & FUEL PUMP SOLD!

WILL SWAP either/both of these Items for a BRAND NEW Walbro GSS432 Fuel Pump, Boost gauge & other gauges of similar value or an electronic boost controller.

1) Mis-matched set of 4 RX7 550cc Injectors. 2 injectors are from a Series 5 FC, and are high impedance (red colored, oval shaped plug) and the other 2 are from a Series 4 FC, and are low impedance (Tan color, square bosch plug). Were used in my GSR lancer, and work fine as a set - there is no issues running 2 different pairs of injectors but you will not be able to do so on stock ECU's. Pretty much every single modern (ie last 10 years) aftermarket ECU can run both high & low impedance injectors without the need for a ballast resistor (for example, these were used with a microtech ECU, but could also do it with adaptronic, autronic, haltech etc...) These were flowed & cleaned a before I bought them, used since but still working fine.

Buy them all for $120, and if you prefer find the matching low-imp or high-imp pair to make a full set you can use on a stocker ECU.



Call Hayden on 0422 903 269
Located near Craigie, NOR

Last edited by oneten; 13-09-2011 at 10:33 PM. Reason: add & remove
Reply With Quote