View Single Post
  #1  
Old 29-05-2013, 03:21 PM
jasonmurray's Avatar
jasonmurray jasonmurray is offline
Sign me up!
From one V8 to another!
 
Join Date: Jun 2007
Location: Thornlie
Posts: 1,084
Thanks: 16
Thanked 22 Times in 19 Posts
jasonmurray at standard level
Default Parts - Wheels, Suspension, STi Engine

Going through my shed and noticed I still have a few parts laying around.

Coilover Suspension with Airbag tops

Comes with fitting instructions and enough air lines to drop straight into your car. Should be only a couple of hours to install.

Also has remote so you can control the suspension from outside the car.

Air Force Suspension

Same suspension as in this car but I have front & rear airbags.



http://i.imgur.com/xOfIzRQh.jpg
http://i.imgur.com/B2oNnQeh.jpg
http://i.imgur.com/ATLZGlrh.jpg

Cost $3000 new.

$1500ono - SOLD



Stock GD/GG Front & Rear Suspension

Nothing wrong with them when I pulled it out and installed BUGNOUT's old pedders suspension.

http://i.imgur.com/wL6UsEJh.jpg

$200ono - SOLD



17" GD WRX Rims

Some gutter rash but nothing really bad.

Near new tyres on them. Only did 2000km before putting my orange wheels on so about 90% tread. The tyres are Bridgestone Supercat 215/45/17.

http://i.imgur.com/tYUCCMth.jpg
http://i.imgur.com/vn6H1fUh.jpg
http://i.imgur.com/WTGUJGdh.jpg

$500ono - SOLD



GG Wagon Cargo Net

Purchased from Subaru Osborne Park but never fitted.

http://i.imgur.com/eATw3qDh.jpg

Cost $120. Sell $60ono - SOLD



Aftermarket Up Pipe

Typical aftermarket Up Pipe. Never used.

http://i.imgur.com/j78RSSxh.jpg

$50ono - SOLD



STi Engine Parts

I purchased a big bunch of engine parts as I was going to build a hybrid STi motor to put into my wagon. Never ended up happening.

STi 2.5 Block. Has 1/10000th scoring on a cylinder. Was quoted $280 to get it honed. Comes with Forged Pistons.

Ver 6 STi 2L Heads. Good condition, have valves and springs. No covers or cams.

Brand new sump and pickup in bag. Cant remember if its suited for TS conversion or not.

Most misc parts to build motor, just need gaskets and covers and should be ready to put back together.

http://i.imgur.com/ss9OBVl.jpg
http://i.imgur.com/hWFJiEq.jpg
http://i.imgur.com/1HaYC4H.jpg
http://i.imgur.com/OcIgbAp.jpg

I have more photos but need to get them off the other camera.

Cost $2500. Sell $1000ono. - SOLD

Not sure if I want to split yet, if people want certain parts I will have to hold until interest in what is left.


PM me for more information.

Thread will be updated when sold and when I find more items.

jase
__________________

TEAM オレンジ


Dyno queen

Last edited by jasonmurray; 26-07-2013 at 12:14 PM. Reason: Items sold :D