Splitter dimensions VF34
Hi all...
Bringing this thread back from the dead...2007!! yeah
Scouring the Internet today trying to find the proper dimensions for my dump pipe splitter...
I have an X force dump pipe and a VF34 P20 turbo..
I've narrowed it down to the following..for a VF34 and in fact all Ball bearing VF's
3mm thick
60mm high.
12mm inside the dump
33mm outside the dump mouth ( into the turbo exhaust cavity)
This also compensates for a gasket thickness of 1-1.3mm crushed..
But the left and right spacing in the dump pipe is a mystery?
Weld it in the middle or directly between the WG and the turbine outlet?
more towards the WG or the turbine exhaust?
Ie see attached picture.
Specifically dimensions A and B..
I know from an earlier post in this thread specifically BXTs who also has a X force dump pipe..
I notice his splitter is not directly in the middle of the dump pipe..
Can anyone shed some light on this dilemma??
PS if you want to make your own splitter..
Ball Bearing VF's (VF 22,23,24,28,29,34) 33mm Sleve Bearing VF's (VF30, 35, 43) 27mm
All TD04/5 22mm
Cheers and thanks in advance..
|