The mechanical/plumbing side of things is finally done. I had a few tense moments drilling next the brake lines. I had to pull it back with one finger while drilling slowly with the other hand.
Picture is blurry but you can see how close the tanks sits to the brake line above it, about 3-4mm clearance.
Before.
And after.
I would have been finished a lot sooner if I had plumbed it according to the Process West install guide, which is very straight forward. Because I am using the Turbosmart reg I had to make some shit up and buy some more nipples. Bought some Bunnings spec angle brackets to hold clamp it in place.
Pretty happy with how it has turned out, it's the first time I have ever attempted anything like it.
Start the wiring tomorrow, ugh.