|
|
LinkBack | Thread Tools | Display Modes |
#51
|
||||
|
||||
Thanks for sorting out my car Mao, HID's are great! Definitely will be back for repeat business. Thankyou
__________________
91 GX Wagon, V2 STi RA conversion. 08 HSV Grange "The boat" 16 WRX STi |
#52
|
||||
|
||||
Hi mate,
You are most welcome. Regards, Mao |
#53
|
||||
|
||||
As mentioned above, we have just done a Philips H4 Hid Conversion on a RS Liberty.
Below are the pics of the install -- do note that the Philips H4 hid conversion kit uses a negative trigger system whereas the RS Liberty runs on a positive trigger system, so you have to reverse the polarity for the hids to work in this case. Philips H4 Globe fites perfectly into the H4 location of the Liberty RS: Philips H4 Plug n Play fully installed: Finished product: |
#54
|
||||
|
||||
We also had the opportunity to fit Canbus compatible HIDs into a 2010 Porsche Caymann over the weekend. Will update with pics shortly.
It has taken us 3 long years to work out the Canbus systems on the newer Jap vehicles and also the BMW, Benz and Porsche. All thanks to Lombardi Bros in Bentley for allowing us to cooperate with them over the years, allowing us to rectify the faulty hid systems on their vehicles that came in for warranty and insurance claims. The CAN Bus is an automotive bus developed by Robert Bosch, which has quickly gained acceptance into the automotive and aerospace industries. CAN is a serial bus protocol to connect individual systems and sensors as an alternative to conventional multi-wire looms. It allows automotive components to communicate on a single or dual-wire networked data bus up to 1Mbps. Canbus hids on late model vehicles also incoperate the daytime driving lights as part of the complex Euro IV compliance system In layman terms, car manufacturers are using a better communication system CANBUS to control the lighting on late model cars, which are also resistance sensitive. In other words, if you use a cheap china made hid conversion system, the dash will immediately pull up a fault code to indicate resistance incompatability in the lighting system. The CANBUS system will then shut down the lighting system and in this case, you will se a flicker of the hid lights once and the hid lights will be permanently turned off afterwards. Last edited by mao; 11-11-2011 at 12:10 AM. |
#55
|
||||
|
||||
Below are pics of the Porsche Caymann Hid Install done in-house at Evolution R.
Porsche uses a singular plug and harness on their headlights. So basically, we had to undo just one elctrical plug on the rear of the entire light and then use the special tool provided to unclick the whole headlight essembly. Placing the headlight carefully on the bench, the whole CANBUS hid install was done neatly inside the headlight. Closer details are not shown in this pic. Final product with no CANBUS warning light on the very expensive Porsche Caymann: Last edited by mao; 06-11-2011 at 11:16 PM. |
#56
|
||||
|
||||
Back in stock! Polarg Japan LEDs for park lights, license plate lights and interior lights.
Refer to previous posts in this thread for more info. Polarg Japan LED park light globes, license plate light globes: To strengthen the side walls of the circuit board, Polarg has added new cones for easier fitment of interior LEds. Below is the NEW Polarg interior LEDs: |
#57
|
||||
|
||||
PM sent mao
__________________
02 STi |
#58
|
||||
|
||||
|
#59
|
||||
|
||||
Evolution R is able to supply you PIAA offroad globes, Philips HID conversion kits, Philips HID Replacement globes for factory fitted HIDs including D2R and D2S, CANBUS compatible HIDS, LED replacement globes from interior and park lights, to license plate LEDs. We also hold massive stock to provide you with prompt sales and after-sales warranty and service.
Below are the Philips gear, PIAA offroad globes, Polarg Leds and other replacement globes we keep in stock: |
#60
|
||||
|
||||
We have successfully installed our Canbus Hid kit to the new
2011 Mazda 3 MPS Turbo 4WD. Late model Jap and Euro vehicles now run a Canbus system whereby normal hid kits will not work with the vehicle due to fluctuations in voltage -- leading to a check error light on the dash. Below are pics of the install. Canbus ballast: 9006 HB4 6000k globe installed: Close-up of factory projector headlight and front view of hids installed (sorry for the bad pics as they were taken in broad daylight): Also just installed another set of Canbus compatible LED park lights and Canbus hids to the new Honda CRV. Below is the Canbus compatible LED parker: LED parklight globe installed: Canbus Hid Ballast neatly tugged away: Canbus hid and Canbus Led park light working in harmony: |
Tags |
canbus, denso, drls, genuine, hid, hids, interior, latest, led, lights, park, philips, polarg, systems |
|
|
LinkBacks (?)
LinkBack to this Thread: http://www.perth-wrx.com/vb/evolution-r/42254-genuine-philips-denso-hids-canbus-hid-systems-polarg-led-park-interior-lights-drls.html
|
||||
Posted By | For | Type | Date | |
85967-51050 | Maxlite 51050 | Weather 51050 | Zip Code 51050 | Wix 51050 | Pendaflex 51050 | Events Near 51050 | Sea Gull Lighting 51050 | Pendaflex Esselte 51050 | propertynorwich.com | Norwich University | Norwich News| Norwich Search | Norwich Sho | This thread | Refback | 22-12-2011 06:00 PM |