Hey all, skimmed through a few pages of searching but there was so much crud, i didnt find what i really wanted.

Now my question is, if i was to swap out them bottom end (short block) of my ej205 for the ej207 would this need to be checked and/or ran over the pits for a engine swap notification?

With the answer to that, would it be the same if i build the long block of the 207 and changed over the 205?

Reasons?

Just need a little clarification!

Thanks,

Eric

__________________
Honda Hannspree Edition CBR 600 RR - SOLD
Yamaha FZ1N - Purchased

you will have to change the engine number associated with the car to the new engine number i think but not sure bout going over the pits

__________________
2013 Toyota Hilux 4x4 - Weekender
1991 Mazda MX-5 - Fun

Nah no pits, only if you're changing size of engine...eg 4 cyl to a 6 cyl.

No pits, but you have to fill out change of engine form.
You may get asked for receipts too.

__________________
Balls.

^ x2
Here's the Link for the change of engine form:DPI Change Engine Form

Take the form and your receipt to them and you'll get paperwork saying that you have an engine with a different engine number in your car. Apparently a lot of people don't even bother but better to be safe...

Installing STi heads make no difference - only if you change the number of cylinders or fuel type do you have to go over the pits. (Forget about RAC horse power rating)

What the fuck would you know.....

I had to change mine for some reason.

__________________
11.1 @ 127mph