[QUOTE=tuna]tail shaft weight fallen off,
wheel weight fallen off, pitch mount loose cv joint bent tailshaft centre bearing flogged out i guess without hearing or feeling the vibration, i'm only guessing[/QUOTE] i thought you were telepathic/psychic!?!? :rolleyes: |
i'll be checking out the noise/vibration again
its fine this morning think the MC training will be a good way of finding out for sure if its serious, it will break! |
im in the same boat at the moment.
coming from the RHF wheel. It increases with speed. I'm guessing it may be the wheel bearing, since I've replaced basically everything else. How can i figure out if its the wheel bearing or not? What i've recently had one: Changed struts to konis (not new) Replaced ball joint to non-oem replacement (i have roll centre kit ready to go in anyways) Pulled out drive shaft to replace cv boots (cv boots replaced by driveshaft place, no cv joint clicking when i had the shaft in) New 4pots + pads + rotors. New tyres and wheels And an alignment at a decent suspension shop |
Are these high frequency, rattle your fillings type vibrations
or low frequency vibrate your dong type oscillations ???!!!???? ;) ;) |
vibrate my dong type.
its not intense. but i can feel it through the footwell. |
does it increase on the brakes?
|
All times are GMT +8. The time now is 10:12 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO