|
|
LinkBack | Thread Tools | Display Modes |
#1
|
||||
|
||||
Installing gauges - where to feed sensor wiring??
Hey guys trying to install some defis i bought last week...only problem is im blind and i cannot find where to feed the wiring through from the interior to the engine bay?
Was following a diy thread on iwsti: http://www.iwsti.com/forums/how-inst...-complete.html But where they mention behind pedals i cannot find any available hole. Im assuming adm is diff to usdm, or like i said, im blind. Any help appreciated. |
#2
|
||||
|
||||
Behind the pedals on a LHD car would be on the passenger side on a RHD here so your looking on the wrong side, Heaps of grommets to feed a wire thru on the passenger side but from memory I fed my wiring thru a grommet near the brake booster. Feed it thru on the engine side and after you have got a decent length thru poke your head under the dash to find the wire.
__________________
Range Rover Evoque Si4 Dynamic |
#3
|
||||
|
||||
yeh i thought it might be the rhd case but still couldnt locate it, i will try looking near the brake booster in that case. Are these grommets exposed or blocked off, starting to think im looking at it without realising.
Thanks |
#4
|
||||
|
||||
Just checked mine, I fed it thru the grommet which is about 1" diameter at 2 o'clock position to the brake booster. You will need to gentley cut a opening into the grommet(one wire is already being fed thru this grommet).
__________________
Range Rover Evoque Si4 Dynamic |
#5
|
||||
|
||||
Ok found it, thanks a lot!
|
Tags |
feed, gauges, installing, sensor, wiring |
|
|