DIY; Make your own BOV elbow for $1!
(I tried posting this in DIY but wouldn't let me...)
[I]Below is a DIY from ozfoz.com ...full credit for originality![/I] Fitting a wrx TMIC to a 99 Gt requires either a factory BOV that bolts straight to the intercooler or if using an aftermarket Bov requires an elbow. Not wanting to pay nearly eighty dollars for a new elbow i thought i'd make my own:- Bought a pair of BMX forks at my local recycling for $1 as they have exactly the correct bend and diameter. [IMG]http://i5.photobucket.com/albums/y164/apg39/BMX20bike20forks.jpg[/IMG] Cut them up. [IMG]http://i5.photobucket.com/albums/y164/apg39/BOV20elbow20emerging.jpg[/IMG] Cut the plate out of a piece of scrap steel. Weld up. Polished and a coat of quality clear. Install. [IMG]http://i5.photobucket.com/albums/y164/apg39/Custom20BOV20elbow.jpg[/IMG] As good as factory :D |
Tino would like this mod :D
|
Hell... I dont need one.... And I like this mod... haha. :D
+100 for DIY. Brent. :) |
haha that so good and cheap!! but a lot of effort for sum thing small:)
|
Job Well done!
|
Where is JimmyS...I'm sure he attempted something this dodgy a while back...LOL
Polar Spec FTW!!! :D EDIT: Similar amount of dodgyness, sorry Polarness: [url]http://www.perth-wrx.com/vb/showthread.php?t=7188[/url] |
Quality at its Best :)
|
All times are GMT +8. The time now is 11:53 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO