Knock Sensor on Motec? - Perth-WRX.com

maddog · #1 27-05-2008, 04:24 PM

Is anyone using a knock sensor with their Motec? It is not an option I have heard being readily used or offered by Tuners.

If it is not commonly used then what would it take to set up? Keeping in mind a Tuners time is not cheap.
and no, I did not do a search first.

tuna · #2 22-07-2009, 06:08 PM

very late bump on this.

motec do have knock modules similar to what is all the rage with autronic owners.

http://www.motec.com.au/aboutknockco...knockoverview/

i would recommend the SKM, so you could use it over other cars.

Quote:

MoTeC’s Standalone Knock Module (SKM) provides individual cylinder closed loop knock control allowing tuners to safely optimise high performance ignition maps. The module is compatible with all 'hundred series' ECUs.
The SKM is housed in a robust aluminium casing and can be mounted anywhere in the vehicle. It is wired between the ECU and the OEM fitted knock sensor.
Configuration of the module requires a competent tuner to carry out a frequency analysis and tune the control system. This is highly specialised work and therefore the MoTeC Knock Modules will only be available through authorised dealers that have undertaken specific training.

PROTOTYPE · #3 23-07-2009, 12:45 AM

DO WANT!!

Might get myself some LAAAAMBDA first though

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode