Perth-WRX.com

Perth-WRX.com (http://www.perth-wrx.com/vb/cmps_index.php)
-   Non-WRX Discussion (http://www.perth-wrx.com/vb/non-wrx-discussion/)
-   -   changing gearbox fluid (http://www.perth-wrx.com/vb/non-wrx-discussion/9471-changing-gearbox-fluid.html)

mr_psi 11-01-2007 04:05 PM

changing gearbox fluid
 
hey guys just need some advice if ya could... you guys been awesome so far!

just changing the gearbox fluid in my 1990 triton because its a bit notchy...

ther is no dipstick for the box.... where do i fill it from then?

the gear stick?

thanks
mark

chee 11-01-2007 04:07 PM

is there a filler hole above the gearrbox drain hole?

mr_psi 11-01-2007 04:09 PM

well at the bottom of the box there is no plug... on the side near the bottom there is a bolt which i would say is to drain it other then that there is no other area to fill from...

jEstEr? 11-01-2007 05:47 PM

on my 323 there was a "check" bolt on the side of the gearbox about halfway up, used to judge how much oil is in the box. drained the oil and filled it up through the check bolt until it started spewing out.

mr_psi 11-01-2007 05:57 PM

ohh alright awesome... cheers

NVRENUF 11-01-2007 07:37 PM

it may not even have one dude. i know au falcons dont have dipsticks. once the gear box fails they just replace them apparently.

chee 11-01-2007 07:46 PM

in the fwd's ive done the gearbox oil in, the filler plug is a few inches above the drain plug on the housing. make sure you can undo the filler bolt before you undo the drain plug. and also make sure that you lower the car so its at its normal ride height before you fill it with oil. if you fill it till it spews when its on an angle you might have too little or too much fluid.

jEstEr? 12-01-2007 06:47 AM

chee makes a very good point, you will shit kittens if you find the filler bolt is stuck and you've just drained your oil :P

nauli 12-01-2007 08:07 AM

[QUOTE=mr_psi]hey guys just need some advice if ya could... you guys been awesome so far!

just changing the gearbox fluid in my 1990 triton because its a bit notchy...

ther is no dipstick for the box.... where do i fill it from then?

the gear stick?

thanks
mark[/QUOTE]

Ring Brody at MMS...he used to be a Mits mech ...


All times are GMT +8. The time now is 11:23 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO