Forum: Mechanicals
20-04-2019, 04:14 AM
|
Replies: 11
Views: 4,639
|
Forum: Mechanicals
30-03-2019, 06:21 AM
|
Replies: 11
Views: 4,639
So I went with the ty754vb1ca and hybrid rear...
So I went with the ty754vb1ca and hybrid rear axles. Wired up the STI DCCD cluster and the controller box. Absolutely loving this gearbox's close gear ratio and the RPMs ain't that bad at highway...
|
Forum: Mechanicals
19-11-2018, 03:17 AM
|
Replies: 11
Views: 4,639
Here is how I intend to proceed:
-Swap the...
Here is how I intend to proceed:
-Swap the transmission to Type RA, ty754vb1ca
-Use the R180 rear diff
-Use R160 - R180 hybrid axles
-Use stock rear hubs
-Use stock driveshaft by swapping the...
|
Forum: Mechanicals
19-11-2018, 03:09 AM
|
Replies: 11
Views: 4,639
|
Forum: Mechanicals
15-11-2018, 04:12 PM
|
Replies: 11
Views: 4,639
|
Forum: Mechanicals
14-11-2018, 06:11 AM
|
Replies: 11
Views: 4,639
GC8 blown gearbox. Options?
So, here's the thing:
Recently the car started to make a slight knocking/tapping sound at idle. The sound went away as I pressed the clutch so I thought is must be clutch / trans related. I pulled...
|
Forum: Mechanicals
14-11-2018, 05:23 AM
|
Replies: 12
Views: 2,729
|
Forum: Mechanicals
26-10-2018, 04:08 AM
|
Replies: 12
Views: 2,729
I want to thank you for all the help. I was...
I want to thank you for all the help. I was finally able to complete the inspection/registration. Eventually the the importer found a suitable VIN code which is like GC8-xxxxxx for JDM Imprezas.
|
Forum: Mechanicals
01-10-2018, 04:13 PM
|
Replies: 12
Views: 2,729
|
Forum: Mechanicals
30-09-2018, 06:26 PM
|
Replies: 12
Views: 2,729
|
Forum: Mechanicals
29-09-2018, 08:11 PM
|
Replies: 12
Views: 2,729
|
Forum: Mechanicals
29-09-2018, 02:07 PM
|
Replies: 12
Views: 2,729
|
Forum: Mechanicals
29-09-2018, 01:18 AM
|
Replies: 12
Views: 2,729
|
Forum: Mechanicals
23-08-2018, 02:09 AM
|
Replies: 31
Views: 7,914
I've been busy lately but I managed to replace...
I've been busy lately but I managed to replace the fuel lines and the FPR. Total list of mods:
-AEM FPR
-AN8 fuel line from the tank to engine bay
-Kinugawa fuel rails, AN6, parallel configuration...
|
Forum: Mechanicals
21-08-2018, 01:53 AM
|
Replies: 31
Views: 7,914
Been busy lately with my work and all but I...
Been busy lately with my work and all but I finally got the mods done.
-New fuel line from the tank to engine bay (AN8)
-AN8 fuel filter
-Kinugawa parallel fuel rails (AN6)
-AEM fpr
And while...
|
Forum: Mechanicals
02-07-2018, 11:18 PM
|
Replies: 31
Views: 7,914
|
Forum: Mechanicals
01-07-2018, 11:14 PM
|
Replies: 31
Views: 7,914
|
Forum: Mechanicals
01-07-2018, 07:40 PM
|
Replies: 31
Views: 7,914
I've got full 12 gauge (4mm^2) wiring to the...
I've got full 12 gauge (4mm^2) wiring to the pump. I did some testing to the FPR by applying compressed air but I didn't simulate the flow as suggested.
I could do some measurements to the pump...
|
Forum: Mechanicals
30-06-2018, 10:47 PM
|
Replies: 31
Views: 7,914
|
Forum: Mechanicals
30-06-2018, 04:01 AM
|
Replies: 31
Views: 7,914
So, I checked the pump again. Nothing obvious...
So, I checked the pump again. Nothing obvious wrong with it. While I was at it, I decided also I rewire the pump voltage supply wires through the service hatch. I used a ring terminal type bulkhead...
|
Forum: Mechanicals
30-06-2018, 03:35 AM
|
Replies: 31
Views: 7,914
|
Forum: Mechanicals
29-06-2018, 10:10 PM
|
Replies: 31
Views: 7,914
Lately I've been noticing that car takes a few...
Lately I've been noticing that car takes a few seconds to start if I don't crank it at the same time when the pump is priming. I just thought it was because of E85. The typical Finnish summer is not...
|
Forum: Mechanicals
29-06-2018, 09:53 PM
|
Replies: 31
Views: 7,914
|
Forum: Mechanicals
29-06-2018, 09:51 PM
|
Replies: 31
Views: 7,914
How big surge tank would I need? I have some...
How big surge tank would I need? I have some extra space in the engine bey since I'm running a japspeed FMIC. If I understood correctly the current fuel pump would feed the surge tank with low...
|
Forum: Mechanicals
29-06-2018, 09:41 PM
|
Replies: 31
Views: 7,914
|
Forum: Mechanicals
29-06-2018, 03:45 AM
|
Replies: 31
Views: 7,914
1999 WRX GC8 stock fuel lines flow capability?
Hello, it's my first post on these forums.
I've been modding my 1999 WRX for E85. Goal was set to +300whp (I'm afraid my 5 speed would not want more :))
Mods so far, at least the ones I could...
|