Rear Sway Bar - Perth-WRX.com

Elrico · #1 13-01-2008, 04:15 PM

On the look out for a good price on a brand new, or second hand (if you have one collecting dust) Whiteline Rear Sway bar and/or Anti-lift kit.

Also are these easy to installed by one that is fairly mechanically minded in a garage?

Thanks,

Eric

EDIT: Sorry should specify that it is a GC8. I take it that it has to be suited to a GC8?

wild_rx · #2 13-01-2008, 04:34 PM

the swaybar is easy to do Eric. can give you a hand if ya need. the anti lift kit is abit harder to fit

vivioman · #3 13-01-2008, 05:05 PM

swaybar is real easy to install. I did it without even raising the back of the car up although that might have made the job easier.

Not so sure about the anti lift kit though.

WhiteRX · #4 13-01-2008, 07:13 PM

Anti lift kit is easy as too. just loosen the two bolts and one unt that hold the front rear lower control arm bush, slide off the old one and put on the new one...

Elrico · #5 13-01-2008, 07:23 PM

Ohh well sounds pretty easy. All i need to do is locate some ;p. So back to the matter at hand after i recieved the infomation that was needed (thank you gentleman), Is there any second hand Whiteline Rear swaybars or ALK's around P-wrx?

WhiteRX · #6 13-01-2008, 08:38 PM

I think that joey86? may have had one for sale. as Tim said, if you need a hand give us a yell.

Elrico · #7 13-01-2008, 08:50 PM

Ahh will do fellas! Much appreciated hey, we'll roll my car on its side in the Canningvale shops carpark and change it over there ey? Just need a few maccas trays to slide her around into position!