bump.... type25 pm sent

__________________
[COLOR="Blue"]If anyone needs T.I.G or M.I.G or small custom fabrication jobs done PM me.[/COLOR]

up she goes

__________________
[COLOR="Blue"]If anyone needs T.I.G or M.I.G or small custom fabrication jobs done PM me.[/COLOR]

anyone? some body must have these layin round...

__________________
[COLOR="Blue"]If anyone needs T.I.G or M.I.G or small custom fabrication jobs done PM me.[/COLOR]

anyone?

__________________
[COLOR="Blue"]If anyone needs T.I.G or M.I.G or small custom fabrication jobs done PM me.[/COLOR]

Davey I have a set of equal length headers in my shed was going to put them on my race car but never did, had them on my bug eye as well for a while.

they are slip jointed to aid in installation, being that you can mig and tig I would suggest fitting them and then welding the slip joints as they leak for about 5 minutes until it all warms up and they seal properly.

Let me know if your interested, for the intake pipe I am assuming your after a silicon jobbie?

if not I have a couple of factory plastic ones.

However depending on what your doing go to the PBMS website, with the strength in our dollar at the moment might get a bargain.

wazza

Cheers mate pm sent

__________________
[COLOR="Blue"]If anyone needs T.I.G or M.I.G or small custom fabrication jobs done PM me.[/COLOR]