|
![]() |
|
LinkBack | Thread Tools | Display Modes |
#71
|
||||
|
||||
![]()
Got a question if anyone can help. I'm doing an oil change on my car(never done one myself) and i was wondering if the oil filter should just twist off or if there is a bolt holding it on as it will not budge and i don't want to break anything.
Thanks in advance
__________________
broken wannabe racecar Wagon daily that has replaced said broken wannabe racecar |
#72
|
||||
|
||||
![]()
It just spins off. You may need an oil filter wrench if it is tight.
|
#73
|
||||
|
||||
![]() Quote:
![]()
__________________
broken wannabe racecar Wagon daily that has replaced said broken wannabe racecar |
#74
|
||||
|
||||
![]()
Oil pan?
__________________
[COLOR=Black]Liberty GT Spec B tuned 240 HP & 372 Nm at the hubs.[/COLOR] "Instead of banning high performance cars - ban low performance drivers" |
#75
|
||||
|
||||
![]()
Yes but the oil ran down my arm first then into the pan
![]()
__________________
broken wannabe racecar Wagon daily that has replaced said broken wannabe racecar |
#76
|
||||
|
||||
![]()
Make sure that the rubber seal from the old oil filter came off with it, as you'll run into trouble otherwise.
__________________
[SIGPIC][/SIGPIC] |
#77
|
||||
|
||||
![]()
Yep the seal is still on the old filter, good thing because i wouldn't have known any better
![]()
__________________
broken wannabe racecar Wagon daily that has replaced said broken wannabe racecar |
#78
|
||||
|
||||
![]()
Ok so did a small mod today... Just got some taillights back from being tinted(very light tint) and thought i would change them over tonight, tested that it all worked before i stuck them in and all good.
Then before i went out i asked my mum to stand behind the car and see if all the lights are working just incase and the spoiler light,indicators,hazards,park lights and reverse lights worked but no brakes so after a bit of checking all the globes none where blown, i even got my old lights to check if it would work on them but no luck ![]() After putting all the globes back in i was testing them again then my right hand park light stopped working and later came back on ![]() ![]() Any suggestions would be greatly appreciated Ohh and to top it off i got a flat tyre aswell probably fom the incident with the high curb, go to change it come back 10 mins later and the spare is flat too.......... what a great day
__________________
broken wannabe racecar Wagon daily that has replaced said broken wannabe racecar |
#79
|
||||
|
||||
![]()
Just curious, what is getting done on the service? You only changed the oil and filter like 2 weeks ago?
As for the brake lights, get acquainted with a test light. Sometimes fuses can still look good when they are blown. Check the globe holders for corrosion. Check that you have put dual filament stop/tail globes in. |
#80
|
||||
|
||||
![]() Quote:
When you do your weekly air pressure check's on tyres Get into the habit of checking your spare wheel's air pressure as well.. As I have had flat tyres in the past ONLY to find the spare is flat too Told my sons the same thing too .......... Only to get a call.. DAD I HAVE A FLAT, AND THE SPARE IS FLAT ![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
04 3' Cat Back Xhaust. Hi Flow Cat Incl. | shamrock | For Sale | 1 | 29-03-2011 01:35 PM |
Cat Converter | wilko | Mechanicals | 16 | 10-03-2011 06:02 PM |
FREE: Devon rex cross sphinx cat | AntonRX | The Quokka | 0 | 28-03-2009 07:11 AM |
Heat wrapping a cat (not the meow kind) | SilentKilla | Mechanicals | 17 | 12-03-2008 07:01 PM |
High flow cat advice needed | e-rex-shon | Mechanicals | 0 | 15-08-2005 10:37 AM |