Thread: Flashing CEL
View Single Post
  #11  
Old 20-07-2009, 10:58 AM
Rossco's Avatar
Rossco Rossco is offline
Perth WRX Old Skool Cool Dude
Member
 
Join Date: Apr 2007
Location: Perf, NOR
Posts: 5,467
Blog Entries: 11
Thanks: 54
Thanked 100 Times in 79 Posts
Rossco is a guruRossco is a guru
Send a message via MSN to Rossco
Default

Power FC CEL's...........


● If the engine check lamp illuminates at startup...
① When lit...
・If lit, there is a possibility that either the map sensor, throttle position sensor, intake air temp sensor, or water temp sensor is damaged.Turn the engine OFF immediately and have your local Power Excel shop inspect the vehicle.

② When driving...
・If flashing in 0.1second intervals for 3 times,the vehicle may be detonating
Detonation causes severe damage to the engine
Release the accelerator pedal immediately if detonation occurs.

・If flashing for 0.5 second intervals, the injectors may be at maximum capacity.
If the injectors are at maximum capacity the injectors may not be able to deliver the required amount of fuel to the engine. Increase the fuel pressure or change to larger injectors.

● If a fuel cut occurs while driving...

・Fuel cut caused by the Rev Limiter
This fuel cut will occur when the engine RPM's exceed the Rev Limit setting

・Fuel cut caused by the Boost Limiter
This fuel cut will occur when the boost exceeds the boost setting by 0.25kg/cm^2. The boost setting is adjustable with the FC Commander.
__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER]
[CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER]
Reply With Quote