Thread: Motec / Delco 3 bar MAP sensor
View Single Post
  #4  
Old 27-01-2010, 07:50 PM
[REXPLOIT]'s Avatar
[REXPLOIT] [REXPLOIT] is offline
Subaru Tech Division
Member
  
Join Date: Aug 2005
Location: In the 'Vale.
Posts: 1,246
Thanks: 0
Thanked 0 Times in 0 Posts
[REXPLOIT] at standard level
Send a message via MSN to [REXPLOIT]
Default
Quote:
Originally Posted by jEstEr? View Post
I have the motecz wiring diagram here somewhere
^ PnP uses the factory 5 plugs? Wouldnt MAP wiring from the engine bay patch in to the same pinout (A,B,C,D,E #whatever) on the Motec board?

Set me straight... lol. I was just going to extend the (OEM) wiring from the TB, to where the BCS sits, and have the MAP mounted there. Isnt it as Rossco said? That made sense... noting the red wire also travels to other sensors and the like, and blk/grn is earth... so orange would be 'signal'...?

Happy to be corrected, as im not with the car right now...

Brent.
__________________
* [REXPLOIT] - EJ207 2.2L build. Under assembly:
* All Sling - No Bling: Member 002:
* WRX Club of WA member / CAMS member / CAMS registered volunteer:

[SIGPIC][/SIGPIC]
Reply With Quote