View Single Post
  #31  
Old 24-11-2014, 01:58 PM
Rossco's Avatar
Rossco Rossco is offline
Perth WRX Old Skool Cool Dude
Member
 
Join Date: Apr 2007
Location: Perf, NOR
Posts: 5,467
Blog Entries: 11
Thanks: 54
Thanked 100 Times in 79 Posts
Rossco is a guruRossco is a guru
Send a message via MSN to Rossco
Default

Quote:
Originally Posted by NEHoward86 View Post
1) PFR6G Do NOT regap these plugs! I run 24psi on stock plug gaps with the same coils your motor has

2) so how I describe it being installed is fine? Yes - it's fine

3) my throttle body is looking old anyways. If I can get the whole throttle body plus all sensors. Plus New gasket, will it still need a tune? Throttle bodies don't wear out - zero gains by replacing it. Your TPS needs adjustment or replacement after diagnosis on the TPS sensor by a tech.

4) I'm 100% sure its coming from the top plug on the throttle body. Like a ticking sound. once the ignition is switched off there is no power supplied to any engine management components in the engine bay - unless you have a turbo timer.

5) thanks heaps for the reply hey. Once iv trouble shot these items, its going straight to the tuners. And I thought I had a IC leak only cause its the only silicone pipe I didn't replace. I might just replace that one too. Thanks again.

All Wheel Grip Not Rear Wheel Slip!!!
Did you use new intake manifold gaskets when you removed & re-painted it?

Also your car should be running around 18-20psi on that VF22 if it's been tuned properly.
__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER]
[CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER]

Last edited by Rossco; 24-11-2014 at 02:07 PM.
Reply With Quote