|
|
LinkBack | Thread Tools | Display Modes |
#51
|
|||
|
|||
Any advice on how to go about installing a stereo in the most efficient way possible i.e. not back-tracking, so as to save a bit of time and to maintain my patience?
I’m thinking: - Remove passenger seat, rear seat base, sill trims, centre console fascia and original head unit. - Splice and solder Alpine head unit loom to original wiring (I have a wiring diagram from the Subaru service manual so I can match up power, trigger, ground and rear speakers to the original loom). - Install head unit, and run iPod cable to glovebox. - Run RCA’s to where the amp will be (along the centre console) - Position and secure amp. - Run power cable (along the edge of the carpet where the sill covers are, opposite side of RCAs!) and fuse from battery to amp and connect all cables to amp. - Re-wire existing MB quart splits (I integrated them into the original wiring, but running from an amp I'll have to re-wire) - Run wires from amp to crossovers, wire them up. - Run cable from amp to sub, wire it up. - Re-install interior bits. - Crank stereo If anyone has any particular or Subaru-specific install hints they'd like to share, it would be much appreciated I've also ordered one of these nifty accessories, which means I don't have to splice wires into the factory loom for power, trigger, ground, rear speakers, etc. I can solder the Alpine harness onto this, and then just plug everything in Last edited by BALISTC; 05-02-2008 at 08:56 AM. |
#52
|
||||
|
||||
HIJACK!
does anyone know the actual allowable mounting depth of front speakers for a MY00? and not just "my (insert speaker here) fits" as i dont know the size of your speakers...
__________________
Balls. |
#53
|
||||
|
||||
Quote:
2) Remove speaker 3) Insert ruler/tape measure 4) Compare gap to edge of inner door skin with speaker mounting depth 5) ??? 6) Profit
__________________
No more GC8, sad face. [SIGPIC][/SIGPIC] |
Tags |
advice, bit, speaker |
|
|