|
|
LinkBack | Thread Tools | Display Modes |
#11
|
||||
|
||||
As bish suggested... far too small a volume to put my current sub in. Also lack of depth/clearance.
__________________
[I]trolololol[/I] |
#12
|
||||
|
||||
My baby 10" goes alright.
|
#13
|
||||
|
||||
step 3
okay a little progress today.
spent three hours on the box before i go ahead finishing the false floor : D as i need to be sure it fits in the boot with the floor height before the floor gets bolted down. step 3 you will need either a jigsaw or a drop saw(preferred) i used a jigsaw cut out the pieces you require if its for a gd wrx your measurements will be the same as mine i will post these later. depending on the size of sub you use the litre-age will be different for you're box so keep this in mind i decided to go un ported for now but may consider it later thats completely up to you. you will need. *jigsaw/ drop saw *silicone i used sika - flex *screws i went with mdf chipboard 45mm long x 50 *of course MDF i used three sheets 450mm wide by 1200 long x 18 (22 would be best) lots left over *i also used glue in every hole a screw went in i used a proper sealant as i know my sub pumps hard. * straight edge of some sort *tape measure *marking pen will post up measurements later tonight this is just the box for the sub it is not a final product this won't even be seen once i am finished so it isn't the best looking and is covered in glue as its not important what it looks like its more important what it sounds like. many screws : D finished box will test sound later if its shit ill try again : ) |
#14
|
||||
|
||||
how is this going to sit in your boot? in the spare wheel well?
__________________
Twin Scroll GC8 DCCD FTW... tune and on road shortly!! |
#15
|
||||
|
||||
put some speaker foam in there, and maybe carpet the box for cosmetic appeal?
__________________
2005 WRX STI |
#16
|
||||
|
||||
Oh your only running one 12" I thought you were running two my mistake, I'm on my way to bunnings now to get my mdf. Are u puttin this box in the spear wheel arch or towards the back seat??
|
#17
|
|||
|
|||
I dare say he's not finished....
|
#18
|
||||
|
||||
no where near finished the box will sit against the back seat and two amps will sit along side it there will be a fancy cover piece to go over all of this you will only see black carpet or possibly blue carpet haven't decided and all you'll see is a sub and two amps : D
will be putting foam in later box was necessary to make sure i didn't make the false floor to high thanks impresiv your on to it ; ) also any one know if i should deaden on top of the mdf floor or on the boot floor I'm assuming boot floor but worried ill waste time and money doing that part wrong lol also people sub box sounds amazing needs a little more sealant as i was in a hurry but wanted to try it any way. will work more in this in a few days and post more as i can next step is the amp racks : D thanks for following hope I'm being helpful |
#19
|
||||
|
||||
In my last box I made, I never used the foam in the box and it sounds alot better the the one I done with foam.
|
#20
|
||||
|
||||
so here are the measurements i used if anyone is interested bare in mind this is the size i used due to height restrictions as the false floor takes up a fair bit of height : D
also this is still not finished peeps hold on a bit longer its close ; ) |
Tags |
boot, diy, install |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Home DIY Artificial Lawn Install | American Dave | Non-WRX Discussion | 30 | 17-12-2010 08:17 AM |
DIY H Brace install | Jezza | DIY Mechanical Modifications | 6 | 29-04-2009 03:17 PM |
02 STi boot install | scooby99 | Cosmetic | 6 | 28-01-2008 03:56 AM |
URGENT SALE!!!! Custom Boot Install for RS Liberty FOR SALE | PROTOTYPE | For Sale | 0 | 09-05-2007 12:45 AM |
Car Stereo: Full MY99/MY00 Boot Install | geoff | For Sale | 0 | 04-01-2006 12:40 AM |