|
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
wheel.
Hey guys.
Just wondering whether 18x8.5 with a +35 offset will fit an o5 sit. Thanks for the advise. |
#2
|
||||
|
||||
yes if the pcd is 114.3 x 5 but you will be wanting to roll the guards, pump the penders a bit and run some negative camber so you will need coilovers, good wheel alignment too
__________________
Funny looking German Subaru |
#3
|
|||
|
|||
Thanks.
ATM i am running the prodrive gc 010g which are 18X9.5 with i think a +32 or a 37 and they stick out a lot and rub hard. they stick out about 20mm. has any one got any good combos |
#4
|
||||
|
||||
As per A.D, but you won't need to pump the fenders, just a good flat roll (AutoFX, Dentcraft yada yada).
There's a few GD owners running 18 x 9 +38's on here so you shouldn't have a problem. Read this thread.
__________________
Ryan |
#5
|
|||
|
|||
thanks for the help.
|
#6
|
||||
|
||||
Why not find something closer to the stock offset.
__________________
hello my name is tommy i don't have a Subaru |
Tags |
wheel |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY :- Wheel Painting | RoughStilin | DIY Mechanical Modifications | 21 | 19-08-2011 07:56 AM |
WTB - Old Steering wheel GC8 | GX-REX | Wanted | 3 | 16-04-2011 02:50 PM |
KKR Forged Wheel nuts group buy Part Deux.. 12 x 1.5 and 12 x 1.25 mixed!! | BALISTC | Non Commercial Group Buys | 37 | 02-10-2010 01:31 PM |
Project Kics - Made in Japan wheel nuts, hub rings, spacers, valve stems, valve caps | Vision R | The Former Workshops Forum | 0 | 15-05-2009 08:28 PM |
Gearbox broken by wheel aligner, Please help... | dabomb789 | General Subaru Discussion | 18 | 22-07-2007 06:31 PM |