Care and maintenance of Philips HID system:

1) When turning on the Philips HID system, always leave lights on for more than 3 minutes. This allows the capacitor in the ballast to charge up properly and thus will increase the lifespan of your hid system.

2) Always keep ballasts away from areas that will expose them to water and unnecessary moisture. Although Philips ballasts are water-resistant, keeping them in a dry area will increase their lifeline.

3) Always keep ballasts away from heat. Do not mount them near the abs motor, radiator, exhaust manifold and turbo.

4) Installation of globes with the exception of 9005 and 9006 should be done with the supplied seal fitted. This prevents moisture from getting into the headlights and onto the globe, thereby causing damage to both the globe and headlight lens itself.

Guys, we have managed to intergrate our Philips ballast with the stock JDM STi headlights and factory D2S globes.

Also we can fit the JDM headlights using the standard H4 harness.
In doing this, we are using back the factory bugeye harness, relays and fuses without requiring any further parts.

Below are pics of todays job we did on a P.WRX bugeye wrx:


Below: Wiring process --- unfinished.



Below: More wiring in progress.



Below: More wiring almost there.



Below: Finished Product!



Below: Factory park lights with JDM factory HID globes turned on.



Below: Factory parklights with factory HID globes with high beam turned on:

hey mao just me again, i hope you are not sick of me asking so much but be sure that it will pay off for you ok?!

just wondering if you could get in the phillips extreme vision globes?

btw mao, would you be free this tuesday? i wanted to pop in to discuss your services ect and properly meet you. i know you were busy the other time i went in

yas

__________________
98 gf8 Rip

Hi yas,

Ask anything you want. It is part of my job.

Yes would be able to get you the extreme vision globes, will chk it up with philips Australia in the next few days. Havnt stocked any of that before.

Be leaving for Japan on Wednesday for a week and we are getting the 4-poster installed tmr, so might be a little bz tmr, but hey, just drop in and will fine some time for a chat.

any reason for not stocking them not popular or something? it was just sought of a suggestion + i think poeple on here have used them before and said that they were good. i know hid's are much better but just the cost factor as these globes are not even $100. then again hid will last longer ect so i will have to do some thinking and research

thank you for helping

__________________
98 gf8 Rip

Polarg M4 Park lights. These are produced by Nissei Industries in Japan and are rated at 5000k. These are Canbus compatible and suitable for all Subaru models. As usual, these are made in Japan and top quality.

P.WRX Price -- A$15

On my setup, the HIDS turn off when high beams are on. Is this normal/how it's meant to be?

__________________
[SIGPIC][/SIGPIC]
Should have bought an STI

Can you supply/install HID's to a set of Hella Rally 2000's? Can send price via PM if you like.

If so, may have multiple sets ready to go

__________________
[SIGPIC][/SIGPIC]

PM sent.

Phillips set installed.