|
|
LinkBack | Thread Tools | Display Modes |
#21
|
||||
|
||||
Well yeah, or short block with no labour
Just a bad guestimate that things are possible, but require some creative thinking. The stumbling block of building a good car for under $15k is the initial car purchase price. You can buy a 93 GX cheap, but then you have more work/money converting it. You can buy a later model WRX ready to go, but then have a higher end cost as you break and replace bits. You can get GD JDM engine, gearbox etc whole for say $8k. Add cheap shitter GC8 shell and it adds up to under $15k for a 'weapon'. Practically, unless you are doing it all yourself, it will cost a lot more and then there are the hidden costs of making things work.
__________________
[COLOR="Gray"]550Nm off a 2L... Just wish it was in the dak dak...[/COLOR] |
#22
|
||||
|
||||
Damo's car (undr8td) for $15k ...PFC, suspension & 6 speed.
Or RS lib - 207 - link - vf34 - done.
__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER] [CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER] |
#23
|
||||
|
||||
get an early gx impreza - $2k
buy a jdm bugeye sti & get it chopped in half & sent over - $11k do all the work yourself & swap over the entire driveline/loom/dash/ecu etc $free leaves you a couple of grand to play with for any extra's you might want would be an awesome project & you'll end up with a nice tidy package |
#24
|
||||
|
||||
that! it used to be my old car so it's been looked after very well
__________________
Member of the 18-35 club and proud of it! (For another 5 years...getting old) New toy has arrived, 1/4 mile in 11.2 sec and only 114hp! |
#25
|
||||
|
||||
Quote:
I have been in many a fast car. Its not the point of the thread - Anyone can troll carsales and forums for links. A bit of creative thought and discussion is the goal.
__________________
I am only an asshole on the internet :) [SIGPIC][/SIGPIC] |
#26
|
||||
|
||||
Quote:
__________________
221.7KW-ATW 498.5NM MMS ROLLER DYNO & BUILT BY STi NINJAS, BUILD #318/600 EBISU SUBARU, SHIBUYA-KU TOKYO |
#27
|
||||
|
||||
yeah the last few GRB sti's i've seen kris bring in are going for around $15-16k hence my wind back from your initial idea to bugeye to keep in budget
|
#28
|
||||
|
||||
All good, same idea.
__________________
221.7KW-ATW 498.5NM MMS ROLLER DYNO & BUILT BY STi NINJAS, BUILD #318/600 EBISU SUBARU, SHIBUYA-KU TOKYO |
#29
|
||||
|
||||
When you say "performance" what do you have in mind for the vehicle. Is track beast, drags, fast streeter or all of the above?
__________________
The older you get the more you realise that no one has a clue. Every one is just winging it. MY05 STI |
#30
|
||||
|
||||
buy my legacy g1 s2
__________________
WRC is for Boys Group B was for Men. |
Tags |
15k, challenge, confirm exhaust hangers on new car..., experts, forum, performance, perth, subaru, wrx |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
WRX/STI Factory Specs - Performance Figures | WRXTASY | General Subaru Discussion | 9 | 06-12-2008 12:41 PM |
So whos the wanker at Perth WRX? | teejay | Non-WRX Discussion | 68 | 26-09-2008 09:12 AM |
Subaru Wrx STI 380S | saturation | General Subaru Discussion | 8 | 24-07-2008 10:50 AM |
Subaru WRX Maintenance Manual Wanted | SICKMREX | Mechanicals | 2 | 24-03-2008 03:55 PM |