|
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Some advice please
hey every one am new was hoping to get some advice rescently got conned into buying a wrecked liberty was hoping to put it in a sand rail but didnt realise how complicated the immobiliser is and how computer orientated it is so now i have this wreck sitting at home and am not sure weather to continiue with it or not if i do means alot more money to get it done properly some one suggested changing header to a wrx one and converting it to single turbo with a stand alone ecu and rewiring but thats gona cost at least 5 thousand and theres the thing every one saying they are unrelible and prone to breaking down and they have too many sensors so my quastion is is there a way i can do this does any one have any words of wisdom
|
#2
|
||||
|
||||
Sell the Wreck?
Buy a non-fuel injected motor? Any injected motor is going to need to be re-wired to work in a rail. I wouldn't call 300,000km endurance unreliable lol!
__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER] [CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER] |
#3
|
||||
|
||||
Glad you understood that one sentence paragraph Rossco...
Nick, if you want people to take your question/s seriously, I suggest you try and use some punctuation. People aren't really going to want to help you if they can't clearly understand what it is you are after.
__________________
Now handles like a cat on carpet |
#4
|
||||
|
||||
I reckon you need to find a full stop.
Search Gumtree, Ebay, I don't don't care where... just find a full stop. I read two lines and stopped and disregarded your entire post. |
#5
|
||||
|
||||
I ran out of breath and died while reading this.
|
#6
|
||||
|
||||
You do understand there's no point, the competition is pretty much redundant?
__________________
[SIGPIC][/SIGPIC] |
#7
|
||||
|
||||
Single turbo swap then get a aftermarket ecu that not pnp and make a custom loom with only the stuff you need
|
#8
|
|||
|
|||
Untitled Document
My loom cost $660.00 Call Al You have a full wiring loom from the car. It's in a box. I would like you to pin out to a basic loom for a buggy engine only. Cost please Cut the crap as he will hang up the phone on you |
Tags |
advice, b4 ej208 twin turbo, conversion |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Time to find a new Mechanic - advice appreciated. | judas-savior | Mechanicals | 23 | 19-03-2012 01:25 PM |
Advice on some new rims! | Ninja | Cosmetic | 32 | 23-07-2007 09:06 PM |