|
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Timing belt woes
Hey, i have just tried to do my timing belt and had a problem.
I followed the instructions word by word, however when i got to the stage of taking it off. The two cams on the right spun as i pulled the belt away. I have just looked at the cams on my other stuffed motor and when the notches are positioned correctly, all the valves on the right were not closed, whereas they're closed on the left side of the motor. I suggest this as the reason it spun on the right. They spun quite fast about 180 degrees both of them. I didnt hear any metal on metal action, but i fear the worst. Does anyone have any suggestions on what i should do? Should i just try turn them back the way they came? Thanks, Coci |
#2
|
||||
|
||||
happens all the time when doing timing belts, i wouldnt worry about it. Just put them back where they were
__________________
Version 6 STI |
#3
|
||||
|
||||
just make sure they arnt 180 degrees out ..... ill tell you a story one day...
|
#4
|
||||
|
||||
is it possible? they have marks that have to line up with the timing covers and marks that line up with the marks on the pulley's.
Would run a bit strange though
__________________
Version 6 STI |
#5
|
||||
|
||||
All arrows at 2 o'clock then line up the marks. The Passenger side always spin, the valves will not hit anything as they are closing when the cams spin and if you have the crank lined up properly the pistons are halfway down the bores.
|
#6
|
||||
|
||||
dont worry they dont spin hard it sounds worse than what it is, they just spin a 1/4 of a turn just turn it back put the belt on , turn it over by hand to make sure nothing hits and you'll be fine
__________________
Marti Car: C Red S13 Silvia 2.3l 400+rwhp-SOLD Daily ae82 4age corolla (light mods)-Sold Daily:SWB GQ Patrol Will be a 03-04 STI next |
#7
|
||||
|
||||
P.s It's o.k to swear when you skin your knuckles!
__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER] [CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER] |
#8
|
||||
|
||||
welcome to 2008?
__________________
MY93 Impreza GX 1.8L, 0hp, 0nm |
#9
|
||||
|
||||
if it wasnt brought up now, I probably would have in about a week when I do my timing belt. My baby is all grown up, 6 figures on the odometer now
|
#10
|
||||
|
||||
least u didn't have to do it twice. this is a defiant. MAKE SURE THERE'S A DECENT CAP FROM THE GUIDE TO THE BELT OTHERWISE IT WILL CHOP OUT THE BELT. get some line lockers helps hold the passenger cams pulleys together.
|
Tags |
belt, timing, woes |
|
|