hey hey dudes and dudettes
just got back from a work trip only to find me passenger window smashed in and some goodies taken from me car. so basically im trying to find out how to fit a passenger front window to a subaru my99 model. any help would be much appreciated

Ive take it out b4, quite tricky.

Tiny flat head. 10mm Sockets

Use the tiny flat head. Be real delicate with all the plastic sockets that holds the door trim and the little legs that holds the inside door hinge.

Once that is off, u should still have the plastic sheet for sound proof purposes. sorta take it off following the edges. Dont break it...you will need to stick it back on.

Inbetween the door, where the window sits, right at the top there should be two cushion lookalike things. Undo them.

I find it easier when the window is half to all the way down....gives you more room to work with. There should a bar(around 1.5-2cm wide) running across the door attached to the rails where the roller sits. There should be 2 10mm bolts. Undo them...after that it should slide out. It gets abit tricky when your sliding it as well. Slow and steady wins the race here.

I might of missed a few steps...but its along the line of that! If it sounds complicated or lack of tools. Take it to a panel beater or something GL

__________________
STi Version VI

I have both front & rear here, both tinted $50ea if you still need one.

__________________
Beaten up old 98 Gen 2 Liberty, 13.0, stock V3 STI running gear.
07 Transit motor home
69 VF & 70 VG Valiants needing full restoration
Yamaha Zooma 50cc rocket hopefully going with the Transit.