|
|
LinkBack | Thread Tools | Display Modes |
#1
|
||||
|
||||
2003 STi ECU pinout/wiring diagram
Can anyone help me in telling me/identifying the pinout or colour of the wire on the ecu loom for :
*Ecu boost control *ECU 12v *ECU fuel injection signal cheers T |
#2
|
||||
|
||||
Don't know if they are accurate, but these might help:
http://www.innovatemotorsports.com/r...20-%202004.pdf http://www.northursalia.com/modifica...ng/wrxpin.html
__________________
[COLOR="Gray"]550Nm off a 2L... Just wish it was in the dak dak...[/COLOR] |
#3
|
||||
|
||||
yep got it,
to answer my own question - 2004/5 WRX STi ECU (US version) 1. Wastegate control solenoid valve - B134 - pin 32. 2. Ignition switch (10-13v) - B137 - pin 15 3. Fuel injector #1 - B136 - pin 6 Last edited by waxdass; 17-09-2008 at 11:05 AM. |
#4
|
||||
|
||||
bump
the above diagram seems like its a 2005 spec STi diagram Does anyone have information on a 03/04 STi (aussie/jap) ecu? So far, the closest pins that I got that look like the blocks on my ecu are: *Ignition 12v (i got pin 5, B134) *Boost control solenoid (i got pin 24, B84) *Injector #1 signal (i got pin 6, B137) (from a 2004 US WRX) |
#5
|
||||
|
||||
btw - might want to make this link a sticky:
2004 STi service manual http://ken-gilbert.com/wrx/STi_Manual/index.htm doesnt apply to 03/04 ecu tho. |
#6
|
||||
|
||||
ok finally solved it!!
- Fuel injectors: #1 E1(pink-B84), #2 D6(PL-B137), #3 D5(PB-B137) and #4 D4(PG-B137). - Wastegate: E24(BW-E84) The fuel injectors show ~12v upon key-turn 2 (pre crank). you must enter the pin code in the brant to show the voltage!! Otherwise - it limits it to ~2.5v - as I learnt the hard way tearing out my hair. Below is the Autronic SM4 wiring diagram that helped me (relevant to ADM 03/04 WRX STi's) **note block numbers are displayed different from autronic to subaru wiring diagrams (I have used Subaru pin blocks above) Last edited by waxdass; 22-09-2008 at 10:44 PM. |
#7
|
||||
|
||||
Hi all,
Sorry to bump an old thread. I'm just having a bit of trouble getting my defi vsd installed. I've been searching all night for AUDM STI ecu pin outs and so far the best I've found is this (off wrx.com.au) I'm needing the following: I had a friend translate for me: orange - 12V constant yellow - illumination red - ignition black - ground blue – tacho green – speed in/out Can anyone confirm that pin out F8A above is indeed correct for an 03 (MY04) AUDM STI? Also, I still need 12V constant, illumination, and speedo – any ideas? Thanks, Tin |
Tags |
2003, diagram, ecu, pinout or wiring, sti |
|
|