|
|
LinkBack | Thread Tools | Display Modes |
#1
|
||||
|
||||
Cel - p0037
Equals P0037 - Rear O2 Sensor Heater Control Circuit Low.
Has anyone got a spare rear 02 sensor? This is the second time i have had to replace this sensor, not sure why it dies so easily. Doesn't appear to effect driving in the least. I have no cat in the up-pipe, but believe my exhaust has a cat in it in the mid-section. ASG replaced it about 15k/km ago. Reset the code on the weekend (cheers doug) but returns promptly. Cheers
__________________
[SIGPIC][/SIGPIC] Should have bought an STI |
#2
|
||||
|
||||
put a resistor across the circuit to cancel the cel.
__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER] [CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER] |
#3
|
||||
|
||||
Yeah i've done a resistor mod already to cancel the CEL caused by removing the cat from the up-pipe when i changed the exhaust system.
Not even sure if this sensor actually does anything anymore having had a Verso reflash.
__________________
[SIGPIC][/SIGPIC] Should have bought an STI |
#4
|
|||
|
|||
When my 02 sensor went, i was told to disconnect it and drive around. It felt ALOT better straight away. I was also instructed that i did not need it as some dump pipes dont even allow for it to be screwed in. I assume this is your sensor you are talking about? On the dump, or the uppipe?
I went to repco and got a universal one and replaced it. Havnt had a problem on cold starts for a while. I would normally feel a surge when it was cold.
__________________
Honda Hannspree Edition CBR 600 RR - SOLD Yamaha FZ1N - Purchased |
#5
|
||||
|
||||
Is this the correct rear 02 Sensor for a MY01?
http://cgi.ebay.com/ebaymotors/DENSO...Q5fAccessories Quote:
The one i am talking about is further along, possibly in the mid-section of the exhaust somewhere.
__________________
[SIGPIC][/SIGPIC] Should have bought an STI Last edited by RichX; 18-08-2009 at 01:58 PM. |
#6
|
|||
|
|||
Hmmm your 02 sensor will be anywhere from the dump pipe to the cat. I guess the 02 sensors would work the same as the gc8.
Or otherwise,a bit of speculation, maybe it would throw a CEL if one sensor was reading one thing in the up-pipe and the other sensor had failed? So the 2 values were not within limits of each other. Only reason i say this is my gc8 never threw a CEL without the 02 sensor connected.
__________________
Honda Hannspree Edition CBR 600 RR - SOLD Yamaha FZ1N - Purchased |
Tags |
cel, p0037 |
|
|