|
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Inlet air temp sensor location
Hi everyone,
I have a Delco IAT sensor installed for my MoTeC. It currently resides in the intercooler pipe just before the throttle body. Lets say I went back to a TMIC. Where is the best place to install the IAT?? Cheers |
#2
|
||||
|
||||
I have mine at the base of the tmic near the throttle body running a link g3 ecu at the moment
Sent from my iPhone using Tapatalk
__________________
race tape y pipe running .05 bar till spares turn up. |
#5
|
||||
|
||||
That's pretty much it Joe
Sent from my iPhone using Tapatalk
__________________
race tape y pipe running .05 bar till spares turn up. |
#6
|
||||
|
||||
Avo do a silicone joiner that allows for a sensor right on the throttle body.
http://www.tuspeed.com/product_info....products_id=73
__________________
www.racewars.com.au Last edited by EXPLICIT; 06-09-2010 at 08:08 PM. |
#7
|
||||
|
||||
in the later spec c's they are factory fitted in the inlet manifold.
I would suggest fitting it to the manifold as subaru have.
__________________
[SIGPIC][/SIGPIC] |
#8
|
|||
|
|||
Bump.
Still not THAT keen on drilling a hole in my IC.. is there any way this can be mounted in the silicone joiner that goes between the TMIC and the throttle body? Any ideas? Cheers |
#9
|
||||
|
||||
As above.
Quote:
__________________
RS Liberty - Because WRX's are only good for parts... |
#10
|
||||
|
||||
I have mine mounted in the joiner between the TMIC and throttle body with no problems.
|
Tags |
air, iat, inlet, location, sensor, temp |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY: Installing Autronic Temp sensor | waxdass | Autronic Discussion | 0 | 17-02-2009 07:45 PM |
Air intake | WoodlandsWRX | General Subaru Discussion | 16 | 07-03-2008 02:16 PM |
inlet manifold/heads | teejay | Mechanicals | 13 | 06-12-2007 04:22 PM |
Apex-i EL Exhaust temp. pin/wire issue | zeroaceout89 | Mechanicals | 0 | 06-05-2007 04:44 PM |