|
|
LinkBack | Thread Tools | Display Modes |
#1
|
||||
|
||||
O2 Sensor
Guru's
I'm currently putting on the ceramic coated dump pipes and headers to my gc8. I have encountered a few issues which i require some advice/ part numbers. The o2 sensor hole in the dump pipe was welded up by the previous owner and as a result i need a longer o2 sensor or harness. I do have location infront the the turbo to place the o2 sensor but it will not reach. I can not lengthen the wires between the plug and the sensor as the wires are stainless steel. can i buy a longer compatible o2 sensor? can i buy a harness adapter? would likes some help. tristan
__________________
[I]Personal chef[/I] |
#2
|
||||
|
||||
The O2 sensor I installed recently had the wrong plug.
Point is I spliced the old plug / wires into the new sensor wires using end to end crimps. I then heat shrinked the individual crimps and then the whole set of wires. Has been working successfully. The same could be done to lengthen the wires.
__________________
MY00 WRX. 89 Prelude. 99 CRV |
Tags |
o2, sensor |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ODB2 CEL Codes | Intra | Mechanicals | 40 | 18-09-2012 05:02 PM |
O2 sensors & Ecutek | rubberbudgie | ECUTEK Discussion | 1 | 21-10-2010 11:29 PM |
DIY: Installing Autronic Temp sensor | waxdass | Autronic Discussion | 0 | 17-02-2009 07:45 PM |
Check Engine Light | BM747 | Mechanicals | 9 | 19-09-2006 09:56 AM |
Exhaust Sensor Problem | SilverMY99 | Mechanicals | 0 | 26-10-2005 11:27 PM |