|
|
LinkBack | Thread Tools | Display Modes |
#21
|
||||
|
||||
23 is definitely Air Flow Meter.
You need to take it to a workshop so they can check the circuits and data. Subaru Wangara will sort you out.
__________________
Its just the internet dude, its not real. F.B. Racing 01 WRX (STI badged) 2010 XR5 Focus 06 Impreza Hatch 2.0i |
#22
|
||||
|
||||
map or maf, you got to make sure which one. otherwise drop by my workshop n I will plug in the carman diagnostic and chk for u foc.
|
#23
|
||||
|
||||
It's definitely mass air flow, I have the workshop manual in front of me, code 23 is Mass Air Flow
__________________
Its just the internet dude, its not real. F.B. Racing 01 WRX (STI badged) 2010 XR5 Focus 06 Impreza Hatch 2.0i |
#24
|
||||
|
||||
Check that your MAP sensor is seeing boost.
If you stay under 5 Psi and rev past 4500 does it still breakdown?
__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER] [CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER] |
#25
|
||||
|
||||
ive just spent the last 2 hours or so starring at my engine bay going over every little thing i could see, and i spotted on 1 of the plugs to 1 of the coils was missing abit of insulation so i taped it up went for a drive, and it boosted fine to 9-10 psi.
still had a small hesitation but no where near as bad as before so it has marginally fixed the problem. so now im gonna try bump the boost upto 14-15psi and see what happens. cheerz,james |
#27
|
||||
|
||||
was going to do this as asap im actually considering renewing my whole ignition and fuel system as its near on 20 year old stuff.
hopefully this sorts my problem as im trying to get my car working all sweet so i can put my power fc in i just purchased and get a tune. cheerz,james |
#28
|
||||
|
||||
If you have a fault code its there for a reason. Unless someone has inadvertently unplugged the AFM while the ignition was turned on.
It may be the ignitor more so then the coil and leads. You really need to check fuel pressure as stated above, if you can have a gauge on when it cuts out, might eliminate the fuel system. It may also be the crank sensor. Does it have to be warmed up before it starts playing up?
__________________
Its just the internet dude, its not real. F.B. Racing 01 WRX (STI badged) 2010 XR5 Focus 06 Impreza Hatch 2.0i |
#29
|
||||
|
||||
Quote:
cheerz,james |
#30
|
|||
|
|||
got a set of leads from my old motor that you can have if you like, early wrx motor, coil pack in the centre.
I'm guessing they would be the same?
__________________
Straya |
Tags |
boost, cut |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FS: Blitz electronic boost controller | apg39 | For Sale | 4 | 03-08-2011 09:59 PM |
FS: Blitz Dual SBC boost controller | apg39 | For Sale | 3 | 10-01-2011 08:58 PM |
Boost Cut -- GRRRR! | Jim621 | Link Discussion | 9 | 20-03-2009 04:39 PM |
Blitz I Colour Boost Controller | T-REXX | The Former Workshops Forum | 0 | 24-03-2008 08:37 AM |
Blitz Sbc I-color Turbo Boost Controller - Metal Black | D34THROW | For Sale | 4 | 15-01-2008 03:30 PM |