AUTRONIC SMC EFI VERSION 1.92. is this compatible wid a 1998 wrx or does it need couple extra parts or no good at all just some backround information?

I thought there was only a difference with the pinout of the centre connector between 97/98 -99/00 (when I was looking at Apexi Power FC )

If this was the case - relocating the necessary wires would be easy but.....

The following URL - indicates a substantial difference:

http://www.fs66.dial.pipex.com/Ecu%20connection.htm

You may as well go for a SM2 in this case

Anyone confirm ?

If it's a 1.92 SMC it won't be a plug and play board.

It's a wire in - and yes it'll work, but it won't control your (factory) stepper idle motor - and you'll probably need to send it back to Ray Hall in QLD to get the dwell setup changed to suit the WRX ignition.

You'll need someone to wire it in, too - and it's a fairly big job.

g.

thanks dudes i will ring some subaru tuning specialists 2morro and see whats the go because i can get one of these but if its gonna be shit and pain to install then its a waste alll 2gether

I'm guessing this is what your talking about

http://cgi.ebay.com.au/AUTRONIC-SMC-...QQcmdZViewItem

__________________
MY99 WRX (WRXOTIC) sold
MY02 STi (WRXOTIC) sold
MY09.5 SSV ute

yer is it any good?