|
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
drive shaft extension housing bushing
G'day guys
I'll try and cut a long story short. I was getting some vibrations reverberating through the car around 85-110kph and knocking / clunking at low speed low load changing gears / getting on and off the throttle. So i decided to remove the driveshaft for a balance the diff for inspection and re-shim as once the car was jacked up it was evident there was excessive play. whilst at it i want to replace the extension housing lip seal due to a minor leak. after removing the drive shaft and pulling the extension housing seal i noticed the slip yoke has some wear marks and the seal is in good condition. This has taken me down the path of replacing the extension housing bushing however i cant find a replacement for the life of me.. Subaru manual doesn't have it in on there parts list. If anyone knows where i can find a replacement bush for a 6 speed gearbox i would be most great full. machining a new one will be my last resort. cheers for your help!! Last edited by Fletchy12; 10-10-2019 at 08:54 PM. |
#2
|
||||
|
||||
i would try Japline or Stechnic
|
Tags |
bushing, drive, extension, housing, shaft |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Report: Why Subaru went with rear-wheel drive for its BRZ coupe | rss.feed | General Subaru Discussion | 0 | 20-09-2011 08:00 AM |
CV drive shaft fit?? | Andy sti | General Subaru Discussion | 2 | 16-05-2011 08:01 PM |
Alloy single Drive Shaft | wrx31 | For Sale | 0 | 15-06-2007 09:36 AM |