Have to organise to send a mate's new car to Karratha, anybody know who runs up that way and is reliable?

Cheers,
Josh

__________________


FOR SALE - [MY REXTC] - Custom Polycarb Plates - PM Me

Company call star heads up that way every day or so. I have heard they take cars. give them a try.

I have used Nexus transport twice when I was in Newman and had the WRX. They were cheap and looked after the car well

Note: It did go on a semi and not a car carrier but it was fine.

If it went on the back of a semi, more than likely it was forked on or off... Sorry Dan, but have personally seen various "general freight' companies back load cars in this way and would advise not to use this unless you are 100% certain its ramped on and off.. However, there are always the exceptions. But for heading to Karratha, a car carrier is best, as they don't always fill a truck, general freight companies will ALWAYS fill a truck to Karratha.


For cheap - patricks, no paperwork in the name of pre-damage - post damage report...
For good Service - Mansells - Aussie car Carriers.

Patricks took a car from Karratha to Broome for me, had to leave the keys in the exhaust out in the LIA (close to dodgy accommodation for those who know Karratha) for the driver to pick up at about 3am in the morning. With no insurance against theft from patricks, at my own risk.

have used both when transporting company cars and my own car to Karratha and back again.

Depending on the above, expect to pay $500ish for Patricks and up to $1000 depending on the car obviously for a reliable carrier with damage report.

My 2 cents worth anyway.

Drive it.

__________________
[SIGPIC][/SIGPIC]
Honourable Member for The Darkside

MY07 Mitsubishi Ralliart Colt

Thanks guys, I knew of Mansells going up there but not Aussie Car Carriers. Thanks for the input baylee, will give both a call.

Josh

__________________


FOR SALE - [MY REXTC] - Custom Polycarb Plates - PM Me

Yes it was forked on and off with no problems at all.

This is before I had my ultra wicked 40" milo tin exhaust fitted to it so nothing hung low on it.

It's a new ss so my mate would much rather it go on a car carrier. Thanks for everyone's input.

__________________


FOR SALE - [MY REXTC] - Custom Polycarb Plates - PM Me