I was saying both my bluetooth android app one and my plug in hand held dont communicate with my 99 wrx. I've been told they don't comunicate until 2001/2002.

using the Perth-WRX mobile app

Can anyone tell me if they have had any luck using this on a 04 wrx. Tried a few others and you can connect to them but you get no info from them.

Cheers

I have a wifi one....

Ok I connect to a MY 15... you have to set the IP address in the connection to a static IP address that will be supplied by the manufacturer of the device

For MY99 OBDKey works once put into SSM mode, torque only supports real time information in SSM mode not fault codes though. Haven't tried FreeSSM yet, but I'll do a full write up on how to get it working soon.

Holy thread revival Batboy!

Anyone found a scantool that will read ODB2 and pre-ODB?
My MY11 Liberty is ODB2 of course and I can read that with my current scantool.

My GC (2000 STi Version 6 ecu) ecu doesn't appear to be as my current scanner (below) wont work with it, yet it has the ODB2 plug.
The scanner claims to read all ecu's from '96 or newer using protocols SAE J1850 (VPW, PWM), ISO 9141-2 (ISO), ISO 14230 (KWP2000) and the newly released ISO 15765/SAE J2284 (Including CAN Protocol).



Want a scantool that will read both, or even just one that will read the GC.

Any ideas/suggestions?

__________________
[COLOR=RoyalBlue][B][I]Titanium Reinforced[/I][/B]
MY00 Impreza WRX | MY11 Liberty GT Premium[/COLOR]

All ecu's from 96' if you're referring to US domestic market. 02' to 06' you'll get varies levels of support in OBD2. However if you get something that supports Subaru Select Monitor, you should be fine.

I recommend OBDKey, it'll work with your GC and should work with your Liberty. Email them first though to confirm.

Check out below for more.
http://www.perth-wrx.com/vb/loggers/...sm-obdkey.html