As the title says, I am chasing an exhaust silencer just for peace of mind going over the pits later this week.

Need ASAP guys.

PM or 0405 467 630.

Cheers,


Shaun

I have one - 11cm Just under 4.5"

Will need some "rebending" but its new - never used.

Will need rebending because it was a damn tight fit in my new exhaust and took much swearing and bending to remove it.








SMS "SMS only I do shift work" - 0447 088 878
- Adam

__________________
1989 Legacy GT --> 2001 GD WRX --> 1999 GF8 WRX --> 2001 GD WRX

^ i remember taking that out, pliers and pop... was tight but

__________________
98 gf8 Rip

i have one also, its to suit x-force cannon, one fixing bolt at bottom, its adjustable & idenitical to this one:

Just a tip for the guys taking them out. To avoid bending use the handle from a trolley jack. The little metal nob bit that sticks up so you can lock it in place is perfect for pulling out silencers.

You just slide the handle down the inside of the silencer and yank back on it. That way you're only denting the part of the pipe that you don't see. No need for bending/rebending then.

That's how I used to remove the one on my old MR2.

pm sent

I used a steel coat hanger and bent it into a hook works well and did that 2min after I pass pits in the car park.

__________________
Chinese Mexican
[SIGPIC][/SIGPIC]

hahahaha exactly what I will be doing, just making sure it passes.

Good luck man, I tried with a silencer and still failed!

__________________
Slugeyes Alive!!

What did they fail you on though? The fact that a silencer was in place or that it was still too loud? He never busted me for it being too loud, just that it needed to have two mufflers....??