colour match is close enough to not matter ross...do it do it

__________________
Funny looking German Subaru

They hit 95% at 1.72 bar For a 11.0 afr

Car has a bosch 044 pump & parallel fuel lines, stock reg.

__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER]
[CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER]

Its weird Rossco, we have spoken about this before. My STI with 550 pinks in it maxed out at 301 hp on the dyno, with a 11.2 AFR. The Wagon with yellows in it got to 245 hp at 97% duty at a 11.0 AFR? Are you sure they ate not yellow SARS's or something?

__________________
Cheers,

Simon.

They're the original 290,000km old 440's!

I do have a BIG fuel pump though.

__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER]
[CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER]

Good stuff mate, must be the pump. Great build keep it up will be nice to see a TD05 on it

__________________
Cheers,

Simon.

Here's my first go at Di-nocing something.


First Di-noc attempt by RCC Photography, on Flickr



Di-noc centre console by RCC Photography, on Flickr


Di-noc detail by RCC Photography, on Flickr

I reckon it turned out pretty well for 1 hours work. I was quite Surprised how easy it is to work with - with a little heat from a hair drier.

I'll do the front coin tray & radio surround in the graphite colour over the next few nights, I may do the window switch bezels in gloss black too.

I reckon it will look alright!

__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER]
[CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER]

I have material Rossco, reckon we can do mine?

That looks mint Rosco!
Did you use anything to press around the contours? special tool?

Cheers! I'm pretty chuffed with how it turned out.

The only special tool was my fingers!

__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER]
[CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER]

Id pay you to do mine!

__________________
I am only an asshole on the internet :)

[SIGPIC][/SIGPIC]