Hi Guys,

Can somebody measure where their WRX, Impreza, and AWD Badges are on their boot for me? Have ordered new ones as my car was debadged.

Id like to know how far from the bottom and left sides the Impreza and WRX Badges are, and how far from the right side the AWD badge is under the brakelight.

A photo would be great too - trying to restore this car to as near-original (in appearance) as possible.


Thanks,
Cam.

Impreza WRX sticker

- Distance between bottom of bootlid and bottom of sticker is 46mm
- Distance between left side of bootlid to left edge of sticker is 25mm (bottom left corner) and 32mm (top left corner)

SUBARU badge lettering

- Distance between bottom of bootlid and bottom of SUBARU lettering is 119mm
- SUBARU lettering is 350mm total width
- First letter S starts 200mm from left side of bootlid
- Last letter U ends 200mm from right side of bootlid
- Letters are approx 40mm wide and 23mm high
- Total width of letters is 40mm x 6 = 240mm which leaves 110mm for five spaces between letters. Calculated space between each letter is then 22mm. Calculated start and end points for each letter (from left edge of bootlid):

S = 200mm to 240mm + 22mm gap
U = 262mm to 302mm + 22mm gap
B = 324mm to 364mm + 22mm gap
A = 386mm to 426mm + 22mm gap
R = 448mm to 488mm + 22mm gap
U = 510mm to 550mm

AWD badge

- Right hand edge of AWD badge is approx 100mm from left edge of metal panel/strip (garnish?)
- You can eyeball it easily to fit it centrally between the top/bottom edges of the garnish.

My measurements are approximate and should allow you to mark out vertical & horizontal lines with a non-permanent pen (whiteboard marker) to facilitate fitting.

__________________
Silver GC8 | RallyArmor
"Perth WRX, home of the cynical." - TROLLEY

Wow - champion! Thanks so much