Hi All,

Is anyone here running with the ARC FMIC, info indicates that these are right up there with the best kits available, but they are pricey.....

http://www.arcinter.co.jp/arc/produc...subaru/gdb.pdf

Any feedback appreciated, cost is about $2K

cheers

what sort of feedback are you after?? its only an intercooler....

The missis has one on her Silvia...does the job. No problems....

__________________
2013 Toyota Hilux 4x4 - Weekender
1991 Mazda MX-5 - Fun

Are they worth it, or is a Process West for example just as good.

cheers

ok ok, i see. personally i will be going to a process west cooler when i do mine

havent heard anything bad about either, but cant see the point in spending more on say an ARC over a process west.

__________________
2013 Toyota Hilux 4x4 - Weekender
1991 Mazda MX-5 - Fun

I have one on my gdb, Are they worth it? Would say it does the same job as the processwest units - I only chose ARC because the end tanks look pretty (ricer).

AFAIK process west are a Bar and Plate cooler?

Its a never ending debate, but, I prefer tube and fin. Also, the process west cooler is 1495, plus CAI for 305 so 1800$. Not much cheaper really.

Personally, you have such a complete car, it would be a shame to take shortcuts.

Get a top quality FMIC, I would suggest Trust, HKS, ARC....If you want a custom job it will cost alot more I think but PWR do great cores. Getting someone to do the fab work would be expensive though

__________________
K.E.R.S!!!1

On FMIC's....STI325V6...

the process west one you got, is it tube and fin? I saw where they now do a T & F option?

Im thinkking of getting a FMIC sometime in the next 6 months. considering the HKS Type R kit cause its a bit thicker, with the same surface area. But, at $2900 its pretty steep!

So, am considering cheaper options. Possibly Plasmaman or PWR core and custom piping or the Process West Coolers.

Can you tell me, one side of the piping is smaller than the other isnt it, which side again? Large turbo to cooler and small cooler to engine?

What are the Process ones worth? Assuming you need the intake piping as well?

__________________
K.E.R.S!!!1

Get a PWR core, reverse your manifold Pete and get some custom piping?

__________________
you mirin?

Trust/Greddy Spec R.

It was the bomb.

__________________
[COLOR="Gray"]550Nm off a 2L... Just wish it was in the dak dak...[/COLOR]

would love to Josh, but dont want to pay for it. : P

john, I had that in my bug, did <3 it...

Alas, the type R is listed as being 60 or 70mm thick again? Use to be 100mm, like the HKS one...So not sure whats happening there?

__________________
K.E.R.S!!!1