Hey guys, today i bought an HKS 60mm Mechanical Boost Gauge but when i opened the box i found the instructions were in Japanese, does anyone have a booklet that is in english or can anyone recommend a workshop who will install it cheaply because we were quoted $180 at Cypher.

Cheers Adam

__________________
PerthWRX - Where gay singles meet!

EVO R in bentley
0421 387 888
9358 0288

DIY it
its pretty straight forward

i was planning on DIY but i dont understand the instructions in the slightest, the pictures arent even helpful

__________________
PerthWRX - Where gay singles meet!

all the boost gauges are relatively same
if its mechanical, you'll have 2 wires, one is earth and the other power (usually red). and a hose to fit into your manifold to get boost pressure

do a search on the net
otherwise, PM me and i'll see if i can give you a hand with it

what Joe said. not hard to DIY

ill do it for 50 bucks.

and thats still a rip off

$49 then,

seriously, its a DIY, you cant stuff it up unless you use a hammer.

__________________

Long live the WRC

Ok, i found really good instructions. I know that the black wire connects to the negative battery terminal but what does it mean when it says that the white wire connects to the "12 volt wire when lamp on"?. also i have seen that the rubber tube is meant to be connected between the surge tank and the fuel regulator, is this correct?

__________________
PerthWRX - Where gay singles meet!